And I hope this post will be used to other people too, cause I didn’t find any correct solution except this. It works perfectly on my e46 (330ci auto gearbox) and my e39 (525tds). So I disassemble device and bridge 7&8 pin.Ĭheck pin assignment of OBD connector and then you will seeĪnother thing is that by using OBD1->OBD2 adaptor everything works because in round connector communication lines are bridged and all is transferred to pin7 in OBD2 connector. Here, Pin 7&8 are not bridged but pin1 & 2 bridged. The solution was to disassemble device and bridge 7&8 pin.Since now it has been working flawlessly.” “In E46 2002 only with OBD2 connector BMW SCANNER didn’t want to connect with modules except engine. I try different software version, I also try two laptops (on Windows Vista 32bit, and Windows XP SP3), same problem… I was also able to code the car to automatically roll the windows up by pressing and holding the lock button. I have access to live data from DME module. I just received my BMW Scanner 1.4 (PA Soft) and love it It installed easily and the scanner had no issues connecting and reading codes. I plug-in the diagnostic tool on the car,Īnd when I run “Car Ident” I have these two errors: “Connection error with IDE” then “Connection error with EWS.”īMW Scanner recognized only 2 modules (DME and EGS). The software is well recognized, the drivers too. I bought a USB diagnostic tool Chinese BMW Scanner for my car, 2001 BMW 330i coupe, automatic gearbox.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |